Some Major Safety Concerns Regarding Garage Door Springs

Garage door springs can pose a safety hazard. Replacing, adjusting, and winding a torsion spring can be dangerous and should leave the professionals. A garage door spring that breaks suddenly can send sharp shrapnel flying objects around the garage. Anything or anyone around the garage when this happens is at serious risk of injuries.

Modern sectional garage doors pose little risk of accidents in the event of spring breakage. Recent models of springs are installed over a metal rod and shaft that help the garage door to stable its position. The metal shaft also acts as a retainer so that the broken pieces of the springs are not allowed to go ballistic. On the other hand, the old type of springs can be in different situations. Old models of springs are subject to sending ballistic chunks around the garage in the case of failure.

The old model of springs can be identified quite easily because the newer springs have a core rod that runs throughout the coil of the spring. It is recommended safety feature because the metal shaft and core rod will retain any pieces of springs in the case of breakage. You can see the new and old springs in your local hardware store to check the difference. You can easily see the core rod running inside the coil through the length of the springs. If your garage door springs do not include any safety shaft or rod, it is suggested to replace them with the newer models. Garage door spring replacement can cost upward of $300 depending on the model of the garage door and locality. It is a simple and affordable way to make your old springs as safe as new ones by using cables.

To install the cables in the springs, close the garage door to extend the springs to their maximum position and then measure the extended length of the springs. Double the length and then add two feet extra. For example, if you measured the spring that is 4.5 feet, double it to 9 feet and then add 2 feet extra to make a total of 11 feet. You will need 11 feet of cable for each spring. You also need cable clamps for springs. Thread the cables up at the center of the springs and back down outside the torsion spring to make a loop. Here you need to use a cable clamp to connect the ends together. The process is simple enough, you need to make a retainer to make the garage door spring safer.

If you have two springs mounted at each side of the garage door, add another 12 feet to the length and run the cables up the center of the garage door springs and down the center of the other side. By doing so, you can cut the cost of the project in half to make your garage door safer and functional. The best decision is to just replace the garage door springs with modern self-retaining springs which can cost upward of $150. Garage door adjustment might also be necessary since the new springs will come with different tension characteristics. Without the right adjustment to the garage door, your garage door opener will not perform well. You should call a professional garage door technician to replace the broken garage door springs and make the necessary adjustment.

By spending a few dollars and using some cable clamps, you can make your old springs much safer. It needs your few minutes to prevent what could be a scary accident should your old garage door spring system break and send chunks around.